FAQ

We are not a retailer, we are a manufacturer, we only take wholesale orders.

MOQ: 200sets.

Currently, the products we sell are peel and stick wall tile, wallpaper, floor tile.

EXW, FCA, FAS, FOB, CFR, CIF.

There are between 5 and 10 sheets in a packet, depending on the tile design. The size of each sheet is: Height: 24 to 30cm. Width: 24 to 30cm. When two or more sheets are applied, the overlapping area is reduced by 2 or 4 cm. There are no edge pieces. You need to cut a sheet to make a straight edge. It usually needs 15 – 20 sheets to cover 1 sqm.

If your tiles have smooth surfaces, you can apply our tiles over existing tiles, including the grout lines. * A partial list of ideal surfaces for our tiles includes: smooth ceramic tiled splashback, smooth glass tiles splashback, wall panel (acrylic), wall linoleum, mirror, wallpaper. * Partial list of dusty and porous surfaces that are NOT recommend for tiles: stucco wall, stone wall, unfinished wall (gypsum or plaster), unpainted plywood.

Yea, Bridge Home tiles are bendable. The tile is 3D and the thickness of the tile is about 2mm. It can be installed on the curve of the wall or on the edge of the wall. You can easily cut Bridge Home tiles with a box cutter or a pair of scissors.

Generally Yes. Bridge Home tiles are humidity & heat resistant. They will not be damaged by hot oil. So they are suitable for use in kitchen or bathroom splashbacks. One precaution – To install Bridge Home tiles behind a Gas Cooktop without a protective rear panel, leave an area of 20 cm between the tiles and any open flame.

Tiles are made from moulded plastic as a kind of epoxy. Tiles are 3-D gel effect, self-adhesive wall tiles. Bridge Home tiles are humidity & heat resistant. Tic Tac Tiles are quite suitable for use in kitchen or bathroom splashbacks. They look the same as a real ceramic tile.

We do not recommend using our tiles in the shower. The surface of our tiles is waterproof, but overlapping parts can be weakened in places like showers where they will be constantly exposed to water. Please make sure that your walls are completely dry, and carefully overlap edges when you install the tiles. After that, there should be no issues with the moisture.

Yes. It is very much lighter than ceramic tiles. It is perfect for your caravan. Just check the smooth wall surface and the temperature inside the camper. During installation the ambient temperature must be at least 18 °C and should not exceed 35 °C (not too hot and not too cold).

In order to remove the tiles, you need to apply concentrated heat (use a hair dryer or heat shrink gun) and then use some force to pull the tiles off. (Cooktop heat won’t cause the tiles peeling off) If you stick it on ceramic tiles, it will leave no residue, but if you put it on painted wall, you may lose some spots on the painted wall.

For cleaning, simply use a sponge to restore the shine of Bridge Home tiles. Use a mild non-abrasive household cleaning product such as dish soap, a cream cleanser or a glass cleaner.